NEW QUESTION 16
You ate the NACE Inspector on a job where NACE No. 2/SSPC – SP 10 has been specified. You are finding the Contractor is leaving mill scale on the on surface and as a result you have been rejecting the blast. The Contractor is very upset and has told you that the standard permits up to 5% of the mill scale to remain and still be in be in compliance with the standard.
Your FIRST preferred course of action is to:

NEW QUESTION 17
Which one of these elements is not necessary for corrosion to occur:

NEW QUESTION 18
Inspection documentation is important because:

NEW QUESTION 19
Most industrial coatings are:

NEW QUESTION 20
Non Conformance Reports are completed by the Inspector:

NEW QUESTION 21
Excessive working of the surface with a power grinder can be detrimental because excessive burnishing

NEW QUESTION 22
According to SSPC PA 2 a Spot Measurement is:

NEW QUESTION 23
How many gauge readings does SSPC-PA 2 require within a 4 cm (1.5 inch) diameter circle?

NEW QUESTION 24
The Inspector’s Log Book is generally:

NEW QUESTION 25
Stripe coats are generally applied to:

NEW QUESTION 26
Conventional spray is a good choice when:

NEW QUESTION 27
NACE Level 1 Inspectors have been trained to perform:

NEW QUESTION 28
An inspectors personal log book should contain:

NEW QUESTION 29
ASTM Standards are applicable:

NEW QUESTION 30
Checking is

NEW QUESTION 31
If the specifier does not identify a restriction level in accordance with SSPC PA 2, the default restriction level is:

NEW QUESTION 32
You have just received your NACE CIP Level 1 certification when you are asked to supervise a team of uncertified field pipeline inspectors.
Your FIRST preferred course of action is to:

NEW QUESTION 33
The form of corrosion that has the largest potential for unexpected catastrophic failure is:

NEW QUESTION 34
The most important factor resulting in improved job site safety is: