NEW QUESTION 24
You are redistributing static routes into an OSPF area. Which two statement are true is this scenario? (Choose two.)

NEW QUESTION 25
Which two port modes are associated with STP? (Choose two.)

NEW QUESTION 26
Click the Exhibit button. Referring to the exhibit, how is R5 able to learn the networks that exist within the NSSA?

NEW QUESTION 27
Referring to the exhibit, anycast RP is implemented to ensure multicast service availability. The source is currently sending multicast traffic using group 239.1.1.1 and R3 is receiving PIM register messages, but R2 does not have active source information.
In this scenario, what are two methods to receive the active source information on R2? (Choose two.)

NEW QUESTION 28
You are implementing 802.1x access control in your network of EX Series switches. You have some older client devices connecting to your network which do not support 802.1x.
Which statement is true regarding the older devices?

NEW QUESTION 29
Referring to the exhibit, which two statements are correct? (Choose two.)

NEW QUESTION 30
Referring to the exhibit, which statement is correct when a failure exists on the link between host2 and switch5 on this EVPN-VXLAN fabric?

NEW QUESTION 31
You are configuring, the PVLAN feature on your switches. The PVLAN will span the two EX Series switches shown in the exhibit.
Which three configuration parameters must be enabled on the ports connecting the two switches?
(Choose three. )

NEW QUESTION 32
What is the correct authentication processing order on EX Series switches when multiple Layer 2 authentication methods are enabled?

NEW QUESTION 33
In OSPF, how does a router ensure that LSAs advertised to a neighboring router are received?

NEW QUESTION 34
What allows non-Web enabled devices to access the network on a port configured for captive portal?

NEW QUESTION 35
You must provide network connectivity to hosts that fail authentication.
In this scenario, what would be used in a network secured with 802.1X to satisfy this requirement?

NEW QUESTION 36
You have configured class mode power management on an EX4300 to provide PoE power to telephone and security camera equipment. You want to ensure that security camera power takes priority over telephone power.
Which two actions would solve this problem? (Choose two.)

NEW QUESTION 37
You are asked to configure 802.1X on your access ports to allow only a single device to authenticate.
In this scenario, which configuration would you use?

NEW QUESTION 38
Which two multicast listener registration protocols are supported in the Junos operating system? (Choose two.)

NEW QUESTION 39
You will to route Layer 3 PVLAN traffic within the secondary VLAN.
What is required to accomplish this task?

NEW QUESTION 40
Referring to the exhibit, you have placed the cos multifield classifier on all edge interfaces and configured the relevant CoS parameters.
In this scenario, which two statements are correct? (Choose two.)

NEW QUESTION 41
Which three MSTP parameters must match on all switches in the same MST region? (Choose three.)

NEW QUESTION 42
You are asked to establish interface level authentication for users connecting to your network.
You must ensure that only corporate devices, identified by MAC addresses, are allowed to connect and authenticate. Authentication must be handled by a centralized server to increase scalability. Which authentication method would satisfy this requirement?

NEW QUESTION 43
Referring to the exhibit, which two statements are correct? (Choose two.)

NEW QUESTION 44
You are running OSPF as your IGP. The interfaces connecting two routers are in the ExStart state. You notice that something is incorrect with the configuration.
Referring to the exhibit, which statement is correct?

NEW QUESTION 45
Remote branches connect to the corporate WAN through access switches. The access switches connect to access ports on the WAN distribution switch, as shown in the exhibit. L2PT has previously been configured on the tunnel Layer 2 traffic across the WAN. You decide to move the L2PT tunnel endpoints to the access switches. When you apply the L2PT configuration to the access switches, the ports that connect the access switches to the distribution switch shut down.
Which action would solve this problem?