[2023] Pass HP HPE6-A73 Exam in First Attempt Easily [Q26-Q40]

[2023] Pass HP HPE6-A73 Exam in First Attempt Easily

The Most Efficient HPE6-A73 Pdf Dumps For Assured Success 

HPE6-A73 exam covers a variety of topics related to Aruba campus switching solutions. These topics include VLANs, spanning tree protocols, link aggregation, multicast protocols, quality of service (QoS), and network security. HPE6-A73 exam also covers ArubaOS-Switch configuration, troubleshooting, and monitoring.

 

NO.26 An administrator is implementing a multicast solution in a multi-VLAN network. Which statement is true about the configuration of the switches in the network?

 
 
 
 

NO.27 An administrator is defining a VSX LAG on a pair of AOS-CX switches that are defined as primary and secondary. The VSX LAG fails to establish successfully with a remote switch; however, after verification, the remote switch is configured correctly. The administrator narrows down the problem to the configuration on the AOS-CX switches.
What would cause this problem?

 
 
 
 

NO.28 Examine the partial output of the BGP routing table of an AOS-CX switch:

The switch is learning about four possible path to reach the 1.0.0.0/8 network. Based on this output, which next-hop route will the AOS-CX select to be placed in the IP routing table?

 
 
 
 

NO.29 Examine the configuration performed on newly deployed AOS-CX switches:

After performing this configuration, the administrator notices that the switch ports always remain in the EAP start state. What should the administrator do to fix this problem?

 
 
 
 

NO.30 An AOS-CX switch is configured to implement downloadable user roles Examine the AOS-CX switch output:
Access11config i$ show aaa authentication port-access interface ail client-status Port Access Client Status Details

Based on this output what is the state of the users access’?

 
 
 
 

NO.31 Examine the network exhibit:

The ACL configuration defined on Core-1 is as follows:
If telnet was being used, which device connection would be permitted and functional in both directions?
(Choose two.)

 
 
 
 
 

NO.32 An administrator will be replacing a campus switching infrastructure with AOS-CX switches that support VSXcapabilities. The campus involves a core, as well as multiple access layers. Which feature should the administrator implement to allow both VSX-capable core switches to process traffic sent to the default gateway in the campus VLANs?

 
 
 
 

NO.33 How does PIM build the IP multicast routing table to route traffic between a multicast source and one or more receivers?

 
 
 
 

NO.34 How js voice traffic prioritized correctly on AOS-CX switches’?

 
 
 
 

NO.35 Which AOS-CX switches support weighted fair queuing (WFQ)?

 
 
 
 

NO.36 A network administrator wants to centralize the management of AOS-CX switches by implementing NetEdit.
How should the administrator purchase and/or install the NetEdit solution?

 
 
 
 

NO.37 A network administrator wants to replace older access layer switches with AOS-CX 6300 switches.
Which virtual switching technology can the administrator implement with this solution?

 
 
 
 

NO.38 An administrator is configuring BGP and has two connections to a service provider to two different local routers.
Which BGP metric should the administrator configure to influence which local router the service provider will use to reach certain routes?

 
 
 
 

NO.39 An administrator implements interim accounting for guest users so that ClearPass can track the amount of bandwidth that guests upload and download. Guests that abuse bandwidth consumption should be disconnected from the network. The administrator configures the following on the AOS-CX access switches:

After performing this configuration, the administrator notices that guest users that have exceeded the guest bandwidth limit are not being disconnected. Upon further investigation, Access Tracker in ClearPass indicates a disconnect CoA message is being sent to the AOS-CX switch.
What is causing this issue?

 
 
 
 

NO.40 How is voice traffic prioritized correctly on AOS-CX switches?

 
 
 
 

HP HPE6-A73 exam is an industry-recognized certification that verifies the skills and expertise of IT professionals in Aruba switching technologies. HPE6-A73 exam is designed to measure the knowledge and practical skills required to design, configure, implement, and troubleshoot complex Aruba switching solutions in enterprise environments. The HPE6-A73 exam is a stepping stone towards becoming an Aruba Certified Switching Professional (ACSP), which is a prestigious title in the networking industry.

 

We offers you the latest free online HPE6-A73 dumps to practice: https://www.premiumvcedump.com/HP/valid-HPE6-A73-premium-vce-exam-dumps.html