QUESTION 23

Which effect of this configuration is true?

QUESTION 24
An engineer is troubleshooting AToM on an IOS XE router and receives an error when creating the xconnect. Which command does he need to complete to create the xconnect in AToM?

QUESTION 25
Refer to the exhibit.

PE1 and PE2 are exchanging VPNv4 routes for CE1 and CE2, and PE3 contains the default route to the internet. If the three devices are operating normally, which two conclusions describe this configuration? (Choose two.)

QUESTION 26
What must match in the EVPN and L2VPN configuration mode when configuring EVPN native in a router?

QUESTION 27
An engineer needs to improve MPLS network management by implementing a set of tools to support the NOC engineers in troubleshooting network failures. Which feature should the engineer implement to check the connectivity of the MPLS LSP between the ingress and egress PE routers?

QUESTION 28
Refer to the exhibit.

An engineer is implementing an MPLS P2MP TE solution. Which type of router can serve as the midpoint router and the tailend router in this P2MP TE network implementation?

QUESTION 29
You try to configure MPLS VPN VRF Selection based on a source IP address on an interface that has VRF configured, but you receive an error.
Which action must you take to correct the problem?

QUESTION 30
Refer to the exhibit. If the two devices are operating normally, which two conclusions can you draw from this configuration? (Choose two.)

QUESTION 31
Refer to the exhibit.

A network engineer has been called to configure the four PE devices in order to enable full communication among the four CE devices connected to them. While starting to configure, he experienced a connectivity issue. Which two tasks should the engineer perform in order to begin the process correctly? (Choose two.)

QUESTION 32
Which optional information can be included with an IPv6 ping to support the troubleshooting process?

QUESTION 33
Refer to the exhibit.

Drag and drop the EVC configuration items from the left onto the correct descriptions on the right.

QUESTION 34
What is the primary function of a VRF on a router?

QUESTION 35
While troubleshooting EoMPLS configuration problems, which three parameters should an engineer match between the two ends of the pseudowire configurations? (Choose three.)

QUESTION 36
Which optional information can be included with an IPv6 ping to support the troubleshooting process?

QUESTION 37
An engineer is troubleshooting AToM on an IOS XE router and receives an error when creating the xconnect.
Which command does he need to complete to create the xconnect in AToM?

QUESTION 38
Refer to the exhibit. What is the effect of this configuration?

QUESTION 39
Refer to the exhibit.

A customer carrier running MPLS VPN wants to utilize a backbone carrier to forward traffic and exchange VPNv4 prefixes between the two customer carriers networks depicted. Which two sets of routers must establish MP-iBGP sessions? (Choose two.)

QUESTION 40
In an Ethernet Virtual Circuit environment, which restriction do bridge domains have when STP is running?

QUESTION 41
While configuring the VRF Selection feature, you get an error message after typing the below statement:
Router(config)#no vrf selection source 172.16.0.0 255.255.0.0 vrf VRF1
Which action caused this message?

QUESTION 42
Which BGP feature causes to replace the AS number of originating router with the AS number of the sending router?

QUESTION 43

An engineer is trying to configure an EVPN VWPS. What is the issue with this configuration?

QUESTION 44
Refer to the exhibit.

Which statement about this configuration is true?

QUESTION 45
Refer to the exhibit. A network engineer is implementing an OSPF configuration.
Based on the output, which statement is true?

QUESTION 46
Refer to the exhibit.

Which statement describes the result of this BGP configuration?

QUESTION 47
What is a requirement to share VRF reachability information to all members of a VPN when using IPv6?